|
HOW TO INSTALL THE SCENES |
Step 1: Prepare
Clean out debris in the window well and remove a few inches of rock or other material from the bottom of the window well; this will enable you to roll the panel into place with greater ease when installing it and will put the lower edge below the rocks when they are replaced which will anchor it. Measure your window well in several places from the top to the bottom (height) and from side to side (width). Caution: Be generous with your measurements; the curved dimension may be difficult to measure perfectly. You can always trim more off, but you can’t add any back! Clean the metal or concrete with rubbing alcohol or other appropriate solvent to remove any residue where the adhesive will be placed. If your window well is especially deep, plan it so that about one inch of rock covers the bottom edge. Don’t be concerned if the panel doesn’t reach the top rim of the well; the top likely cannot be seen from the room.
Step 2: Crop
Lay out your Well Scene image-side up on a flat surface. Anchor the corners with something heavy if needed. Do not attempt to roll the panel the other way to flatten it; like other plastic materials, styrene can crack and break if folded back on itself. Mark your window well measurements to select the area that looks best for your window well.
Step 3: Trim
Using a straight edge and a sharp blade/utility knife or using appropriate scissors, carefully cut along the lines you made in step 2. Protect the surface underneath the panel with a piece of wood or cardboard to avoid damage from the blade. Place the panel into the window well along the curve to make any final size adjustments.
Step 4: Attach
Attach the individual Velcro brand fasteners to the metal window well on the ridges that bump out toward the room. Avoid placing pieces on rusted areas, or remove the rust. Put three pieces down each side being sure to hit the spots where the corners will be, and put three down the middle. Put additional pieces along the top edge as needed. Leave the male and female sides connected as well as the backing paper and attach the strips to the metal. Starting on the free side of the rolled panel, remove the remaining backing paper from a set of
fasteners and gradually unroll the panel so that the top is level with the top edge of the metal.
Step 5: Finish
Replace the rock or other material in the bottom of the well to cover the bottom edge of the panel and add any additional decoration desired such as larger rocks, driftwood, or plants. Stand back and admire the dramatic change in your view. Enjoy!
Important note: Do not remove or cover up an egress/escape ladder to install this
product!
Window Well Scenes Limited
Warranty
This product is warranted by the manufacturer for one year from date of retail purchase to be free of manufacturer's defects in material and/or workmanship, including fading of the original image. Components and materials not manufactured by
Window Well Scenes' manufacturer are warranted only to the extent of the original manufacturer's warranty. The sole obligation of
Window Well Scenes' manufacturer under this limited warranty is to replace or repair
(FOB Denver), at the option of the manufacturer, any part which, in the sole opinion of
said manufacturer, is defective. Under no circumstances will
the manufacturer be responsible for mis-installation of the product.
This warranty is made in lieu of all other warranties, espressed or implied, including, but not limited to, any implied warranty of merchantability and/or fitness for a particular purpose or use. There are no warranties express or implied beyond the description of the product on the original product packaging.
Window Well Scenes' manufacturer expressly disclaims liability for incidental, special, or consequential damages of any
nature, and specifically disclaims any liability arising from owner's failure to maintain the product. Replacement of parts or modification of the original
product will void this warranty.
Window Well Scenes' manufacturer neither assumes nor authorizes any person or entity to assume for it any obligations or liabilities not expressly stated herein.
|
|
|
|
|
